Oshkosh S-Series Front Discharge Mixer - Green & Gold

S-Series 6-axle mixer in Green & Gold livery

Presented here is the 1:50th scale Oshkosh S-Series 6 axle front discharge concrete placement truck in the company livery of Green & Gold Concrete. The model is from the second production run and is different from the original production models in that the load span axle at the rear of the chassis is not present.

S-Series 6-axle mixer in Green & Gold livery

The chrome effect rear view mirrors are provided in the box and need fitting to both sides of the cab. These are loose fitting and flop about so a touch of glue may be needed to keep them in position.  There are a host of accurately placed warning and instruction labels throughout the model with many located near the opening cab door.

S-Series 6-axle mixer in Green & Gold livery

The rear mounted engine is revealed under the sprung loaded opening plastic hood with all the engine components fully modelled. The chromed exhaust system, rear mounted radiator with flexible hoses and fine photo etched mesh grill are just some of the details found in the engine bay. The battery compartment and 70 gallon fuel tank are fitted to the chassis sides along with flexible rubber mud guards with printed Oshkosh logos.

S-Series 6-axle mixer in Green & Gold livery

Water hoses are fitted to the large 150 gallon water tank mounted behind the cab while twin air tanks are also visible beneath the drum. There are several realistically cast plastic water hoses, complete with spray nozzles on the model and the front frame has a hydraulically adjustable loading chute and access platform with handrails and photo etched mesh foot panels.

S-Series 6-axle mixer in Green & Gold livery

The single side opening cab door reveals the fully reproduced interior with air ride seat, steering wheel and drive controls, complete with photo etched access steps and handrails. The chute cylinders fitted to the discharge chute are the smallest I have seen on a model and yet they are fully functional. This is another testament to the amount of engineering detail that goes into each and every model from TWH.

S-Series 6-axle mixer in Green & Gold livery

The main driveshaft is visible from the engine to the transmission block where drive shafts then run to the front and rear drive axles. There are two types of tyre fitted to the model and each has an authentic tread pattern. The main drive wheels are larger in diameter and wider while the wheels fitted to the load span axles are small and narrow.

S-Series 6-axle mixer in Green & Gold livery

There are two additional extension chute sections which are stowed on the side of the vehicle and clip into place on the end of the fixed chute to extend the reach at which the material can be discharged. The power chute is able to rotate through 180 degrees with hydraulic cylinders that raise/lower the main section while a flexible simulated material membrane is fitted to the discharge ring, just like on the full sized machine.

A six page full colour brochure is supplied with the model which gives pictures and details of the range of Oshkosh S-Series front discharge mixers. The model is well protected in a two piece polystyrene carton with outer cardboard box, printed with pictures of the S-Series range.

S-Series Front Discharge Mixer - Model Specifications

Model Dimensions

Length: 11.75" / 298mm
Height: 3.25" / 82.6mm
Width: 1.75" / 44.4mm
Weight: 1 lb / 0.45Kg

Box Dimensions

Length: 13" / 330mm
Width: 6.25" / 159mm
Height: 5.25" / 133mm

documents_text02.gif
Download Specification Sheet

 

Save 10% & More - Order From:
Oshkosh Mixer